|
|
|
|
Price $142.95
|
|
Introduction to the Digitrax SE8C
The Digitrax Signaling System is
organized around the concept of “security elements” which are
similar to what U.S. prototype railroads call “plants.” The Digitrax SE8C signal decoder displays aspects for up to
32 heads for 8 individual security elements (plants) using either a LocoNet Throttle or a computer with compatible
software. When used with associated occupancy detectors and compatible
software, the SE8C can be set up to protect the turnout as shown by the
example below. The SE8C decodes switch commands from a throttle or
associated software so that the appropriate aspects are
displayed on the signal heads.
Each security element is made up of three legs designated A, B, & C.
Every piece of track on your layout can be broken down into security
elements to describe how each detection section connects to the other
sections on your layout.
A to B, A to C, B to A & C to A
are the only possible connections, based on turnout position. B to C is not
possible.
Occupancy detection is required for any signaling
system to function. Occupancy detection inputs can be
handled by any LocoNet compatible occupancy detector (Any BDL16 Series
Occupancy Detectors or BD1 Occupancy Detectors used with DS54s will work).
Transponding is not needed for the Digitrax Signaling System.
The SE8C sends its output to the signal driver to drive the signal heads.
Each SE8C has 8 sets of signal drivers, each capable of driving a set of
signal masts. Each set of masts can have up to four heads and each head can
have up to four different lamps or a multi-color searchlight. The heads may
be on separate single masts, dual masts, or gantries. Each mast has its own
signal driver. In practice, each set of signal masts usually corresponds to
the track controlled by a single security element.
The SE8C signal decoder and occupancy detector are
connected to LocoNet so that all security elements on the layout can
communicate with each other as the occupancy of each detection section of
track changes. Since the Digitrax Signal System communicates through
LocoNet, it does not need DCC to work. The SE8C signal decoders and BDL16
Series occupancy detectors can communicate directly with other LocoNet
devices on the layout, they do not need a command station for this
communication. This means that they can be used on
non LocoNet DCC systems and DC systems where LocoNet is added to support signaling.
The SE8C lets you control signals manually from your Digitrax throttles or
automatically through LocoNet compatible computer software such as Railroad
& Company, WinLok and others.
|
|
